Husky H4130 Manuel d'utilisation et d'entretien

Naviguer en ligne ou télécharger Manuel d'utilisation et d'entretien pour Non Husky H4130. Husky H4130 Use and Care Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
7 HUSKYTOOLS.COM
Please contact 1-888-43-HUSKY for further assistance.
Maintenance
Ensure the air line is shut-off and drained of air before removing this tool for service. This will prevent the tool
from operating if the throttle is accidentally engaged.
LUBRICATION
An in-line lter-regulator-lubricator is recommended as it increases tool life and keeps the tool in sustained
operation.
Regularly check and ll the in-line lubricator with air tool oil. Avoid using excessive amounts of oil.
Adjust the in-line lubricator by placing a sheet of paper next to the tool’s exhaust ports and holding the throttle
open approximately 30 seconds. The lubricator is properly set when a light stain of oil collects on the paper.
If it is necessary to store the tool for an extended period of time (overnight, weekend, etc.), generously lubricate the tool through the air
inlet. Run the tool for approximately 30 seconds to ensure the oil is evenly distributed throughout the tool. Store the tool in a clean and
dry environment.
Recommended lubricants: Air tool oil or any other high grade turbine oil containing moisture absorbent, rust inhibitors, metal wetting
agents, and an EP (extreme pressure) additive.
Troubleshooting
Problem Possible Cause Solution
The tool runs slowly or will not
operate.
There is grit or gum in the tool. Flush the tool with air tool oil or gum solvent.
The tool is out of oil. Lubricate the tool according to the lubrication
instructions in this manual.
The air pressure is low. Adjust the regulator on the tool to the
maximum setting.
Adjust the compressor regulator to the tool’s
maximum setting of 90 psi.
The air hose leaks. Tighten and seal the hose ttings with pipe thread
tape if leaks are found.
The air pressure drops. Ensure the hose is the proper size. Long
hoses or tools using large volumes of air may
require a hose with an I.D. of ½" or larger
depending on the total length of the hose.
Do not use a multiple number of hoses
connected together with a quick connect
tting. This causes additional pressure drops
and reduces the tool power. Directly connect
the hoses together.
There is a worn rotor blade in the motor. Replace the rotor blade.
There is a worn ball bearing in the motor. Remove and inspect the bearing for rust, dirt, and
grit. Replace or clean and grease the bearing with
bearing grease.
There is moisture blowing out
of the tool’s exhaust.
There is water in the tank. Drain the tank. (See the air compressor manual
for instructions.) Lubricate the tool and run it until
water is not evident. Lubricate the tool again and
run for 1-2 seconds.
Vue de la page 0
1 2

Résumé du contenu

Page 1 - Troubleshooting

7 HUSKYTOOLS.COM Please contact 1-888-43-HUSKY for further assistance.MaintenanceEnsure the air line is shut-off and drained of air before removi

Page 2 - Service Parts

8 Service PartsReference NumberPart Number Description Reference NumberPart Number Description1 933-312301 Housing 27 9030129 Needle Bearing2 950102

Commentaires sur ces manuels

Pas de commentaire