Husky C801H Manuel d'utilisation et d'entretien télécharger pdf (Page 14)

14

4

How to start (Figure 2)

1. Turn the Auto/Off switch (A, Figure2))

to “Auto” and allow tank pressure

to build. Motor will stop when tank

pressure reaches “cut-out” pressure.

2. When the tank pressure reaches “cut-

out” pressure open the air discharge

valve.

1

Oil (Figure 6)

NOTICE: Risk of property

damage. Use air compressor oil

only. Multi-weight automotive

engine oils like 10W30 should

not be use in air compressors.

They leave carbon deposits

on critical components, thus

reducing performance and

compressor life.

Maintenance

GENERAL MAINTENANCE

Condensate forms in the tank when

there is humidity in the air. Depending

on the environmental conditions, drain

the condensate daily and/or every hour.

For instructions, see Draining the tank

paragragh under Operation.

The safety valve automatically releases air

when the receiver pressure exceeds the

preset maximum.

Inspect the tank annually for rust, pin holes,

or other imperfections that could cause it to

become unsafe.

Avoid using solvents when cleaning plastic

parts. Most plastics are susceptible to

damage from various types of commercial

solvents and may be damaged by their use.

Use clean cloths to remove dirt, dust, oil,

grease, etc.

Operation (continued)

WARNING: Risk of bursting. If

any unusual noise or vibration

is noticed, stop the air

compressor immediately and

have it checked by a trained

service technician.

NOTICE: When using regulator

and other accessories refer to the

manufacturers instructions.

WARNING: Do not allow brake

uids, gasoline, petroleum based

products, etc., to come in contact

with plastic parts. Chemicals can

weaken or destroy plastic which,

may result in serious personal

injury.

WARNING: When servicing, use

only identical Husky replacement

parts. Use of any other parts may

create a hazard or cause product

damage.

WARNING: Always disconnect

the air compressor from the

power supply, release all

pressure, and allow it to cool

before cleaning or making repairs

on the air compressor.

NOTE: Use 30W compressor oil or a heavy

duty SAE 30W, non-detergent, SF grade

or better oil. DO NOT use multi-weight

automotive engine oils, they will reduce

compressor life. Under extreme winter

condition use SAE-10 weight oil.

NOTE: Crankcase oil capacity is

approximately 29 uid ounces (857,6 ml).

Checking

1. The oil level should be to the middle of

the sight glass (N).

2. If needed remove oil ll plug (L) and

slowly add oil until it reaches the

middle of the sight glass.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 87 88

Commentaires sur ces manuels

Pas de commentaire