6
Operation
1
Operating the spray gun
□ This air operated spray gun is designed to perform a
variety of painting, coating, and nishing applications using
the power of compressor air.
□ Do not exceed the maximum air pressure of 45 psi.
□ The trigger lever of this gun has a two-step design. Press
the trigger lever to the rst step to connect to the air
source, ensuring that air ow lls the spray gun. Press
the trigger lever to the second step to connect the paint
material.
2
Controlling the pattern and uid ow
□ Adjust the air pressure with the trigger pulled and the air
control knob fully open. If reduced air pressure is desired
for some areas of the spray job, use the air compressor
regulator or in-line regulator to reduce pressure as
necessary.
□ Increase the air ow by turning the air control knob
clockwise. Reduce the air ow by turning the air control
knob counterclockwise.
□ Set the pattern size to the desired shape. For a full pattern,
turn the pattern control knob counterclockwise. For a round
pattern, turn the pattern control knob clockwise.
□ Turn the uid control knob fully clockwise until closed to
control the uid.
□ The direction of the fan (horizontal or vertical) can be
adjusted by loosening the air cap ring and turning the air
cap 90 degrees.
□ Trigger a short burst while turning the uid control knob
counterclockwise. Observe the spray pattern on the
target and adjust the uid control knob until the desired
atomization is achieved.
Air Cap
(1)
Air Cap Ring
(2)
Horizontal Fan
(3)
Vertical Fan
(4)
4
1
2
3
1
2
Pattern Control
Knob
(1)
Fluid Control
Knob
(2)
Commentaires sur ces manuels