Husky HDK00600SG Manuel d'instructions télécharger pdf (Page 1)

Operation

Operating the spray gun

□ A low pressure at the spray cap minimizes over-spray,

eliminating paint waste.

□ This air operated spray gun is designed to perform a variety of

painting, coating, and nishing applications using the power

of compressor air. This gravity feed spray gun features the

HVLP (high volume low pressure), which enhances the transfer

efciency resulting in a signicant material savings compared

to conventional spraying.

□ Do not exceed the maximum air pressure of 40 psi.

□ The trigger lever of this gun has a two-step design. Press

the trigger lever to the rst step to connect to the air source,

ensuring that air ow lls the spray gun. Press the trigger

lever to the second step to connect the paint material.

Controlling the pattern and uid ow

□ Adjust the air pressure with the trigger pulled and the air

control knob fully open. If reduced air pressure is desired

for some area of the spray job, use the air compressor

regulator or air control to reduce pressure as necessary.

□ Increase the air ow by turning the air control knob

clockwise. Reduce the air ow by turning the air control

knob counterclockwise.

□ Set the pattern size to the desired shape. For a full pattern,

turn the pattern control knob counterclockwise. For a

round pattern, turn the pattern control knob clockwise.

□ Turn the uid control knob fully clockwise until closed to

control the uid.

□ The direction of the fan (horizontal or vertical) can be

adjusted by loosening the air cap ring and turning the air

cap 90 degrees.

□ Trigger a short burst while turning the uid control knob

counterclockwise. Observe the spray pattern on the

target and adjust the uid control knob until the desired

atomization is achieved.

Pattern Control

Knob

(1)

Fluid Control

Knob

(2)

Air Control

Knob

(3)

Air Cap

(1)

Air Cap Ring

(2)

Horizontal Fan

(3)

Vertical Fan

(4)

1 2

Operation 1
(continued) 2

Résumé du contenu

Page 1 - Operation

6 Operation1 Operating the spray gun □ A low pressure at the spray cap minimizes over-spray, eliminating paint waste. □ This air operated spray gun i

Page 2 - (continued)

7 HUSKYTOOLS.COM Please contact 1-888-43-HUSKY for further assistance.Operation3 Preparing and loading the paint □ Thoroughly mix and thin the pa

Plus de documents pour Pulvérisateur de peinture Husky HDK00600SG

Voir le document Husky HDK00600SG Manuel d'utilisation et d'entretien

Husky HDK00600SG Manuel d'utilisation et d'entretien (4 pages)

Commentaires sur ces manuels

Pas de commentaire

Husky HDK00600SG Manuel d'instructions Page 1

Naviguer en ligne ou télécharger Manuel d'instructions pour Pulvérisateur de peinture Husky HDK00600SG. Husky HDK00600SG Instructions / Assembly Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Pulvérisateur de peinture Husky HDK00600SG

Commentaires sur ces manuels

Husky HDK00600SG Manuel d'instructions Page 1

Naviguer en ligne ou télécharger Manuel d'instructions pour Pulvérisateur de peinture Husky HDK00600SG. Husky HDK00600SG Instructions / Assembly Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Pulvérisateur de peinture Husky HDK00600SG

Commentaires sur ces manuels

Produits connexes et manuels pour Pulvérisateur de peinture Husky HDK00600SG