Husky HDK00600SG Manuel d'instructions télécharger pdf (Page 2)

7 HUSKYTOOLS.COM

Please contact 1-888-43-HUSKY for further assistance.

Operation

Preparing and loading the paint

□ Thoroughly mix and thin the paint in accordance with the paint

manufacturer’s instructions. Most materials will spray readily

if thinned properly.

□ Strain the material through cheese cloth or a paint strainer.

□ Fill the paint canister to the maximum of the 3/4 full capacity

carefully.

□ Set up a piece of cardboard or other scrap material to use as a

target. Adjust the spray gun for the best spray pattern and the

best atomization option.

□ Test the consistency of the material by making a few strokes

on a cardboard target. If the material still appears too thick,

add a small amount of thinner. THIN WITH CARE!! Do not

exceed paint manufacturer’s thinning recommendations.

Painting with the sprayer

□ Begin spraying. Always keep the spray gun at a right angle to

the work surface.

□ Keep the nozzle about 6 to 9 inches from the work surface

throughout the stroke and always keep the gun in motion

while spraying. Stopping gun movement in mid-stroke

will cause a build up of paint and result in runs. Do not

fan the gun from side to side while painting. This will

cause a build-up of paint in the center of the stroke and an

insufcient coating at each end.

□ Trigger the gun properly. Start the gun moving at the

beginning of the stroke BEFORE SQUEEZING THE TRIGGER.

Release the trigger BEFORE STOPPING GUN MOVEMENT at

the end of the stroke. This procedure will feather (blend)

each stroke with the next without showing overlap or

unevenness.

□ The amount of paint being applied can be varied by

the speed of the stroke, distance from the surface and

adjustment of the uid control knob.

□ Use a piece of cardboard as a shield to catch overspray

at the edges of the work to protect other surfaces. Use

masking tape to cover other areas if needed.

6 - 9”

(continued)

1 2

Pas de commentaire

Husky HDK00600SG Manuel d'instructions Page 2