Husky H4830 Manuel d'utilisation et d'entretien télécharger pdf

7 HUSKYTOOLS.COM

Please contact 1-888-43-HUSKY for further assistance.

Maintenance

Ensure the air line is shut-off and drained of air before removing this tool for service. This will prevent the tool from operating if the throttle

is accidentally engaged.

Troubleshooting

Problem Possible Cause Solution

The tool runs slowly or will not

operate.

There is grit or gum in the tool. Flush the tool with air tool oil or gum solvent.

The air pressure is low. □ Adjust the regulator on the tool to the

maximum setting.

□ Adjust the compressor regulator to the tool’s

maximum setting of 90 psi.

The air hose leaks.

tape if leaks are found.

The air pressure drops. □ Ensure the hose is the proper size. Long

hoses or tools using large volumes of air may

require a hose with an I.D. of ½" or larger

depending on the total length of the hose.

□ Do not use a multiple number of hoses

connected together with a quick connect

. This causes additional pressure drops

and reduces the tool power. Directly connect

the hoses together.

There is a worn rotor blade in the motor. Replace the rotor blade.

There is a worn ball bearing in the motor. Remove and inspect the bearing for rust, dirt, and

grit. Replace or clean and grease the bearing with

bearing grease.

There is moisture blowing out

of the tool’s exhaust.

There is water in the tank. Drain the tank. (See the air compressor manual

for instructions.) Lubricate the tool and run it until

water is not evident. Lubricate the tool again and

run for 1-2 seconds.

1 2

Résumé du contenu

Page 1 - Troubleshooting

7 HUSKYTOOLS.COM Please contact 1-888-43-HUSKY for further assistance.MaintenanceEnsure the air line is shut-off and drained of air before remov

Page 2 - Service Parts

8 Service PartsReference NumberPart Number Description Reference NumberPart Number Description1 9OB-03 Snap Ring 23 9OB86823 O-Ring2 9OB-04 O-Ring 24

Plus de documents pour Non Husky H4830

Voir le document Husky H4830 Guide d'installation

Husky H4830 Guide d'installation (1 pages)

Commentaires sur ces manuels

Pas de commentaire

Husky H4830 Manuel d'utilisation et d'entretien

Naviguer en ligne ou télécharger Manuel d'utilisation et d'entretien pour Non Husky H4830. Husky H4830 Use and Care Manual Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Non Husky H4830

Commentaires sur ces manuels

Produits connexes et manuels pour Non Husky H4830